Home

4 Steps to Replacing an Old or Leaking Toilet

Any homeowner will at some point have to replace their toilet. Your toilet could be getting old or leaking. Below are steps to take to repair a leaking or old toilet like a professional plumber.

1. Disconnect the Supply Line

After turning off the main water supply, flush the bathroom to get rid of any water in the tank or bowl. However, a little water will be left in the bowl, and that’s when you will need to use a plunger to force the water into the drain line. You can then use a sponge or bucket to remove the water left in the tank.

2. Install a Wax Seal

Homeowners can use their knife to pry up and get rid of any existing wax seal. However, inspect the underneath flange first to check whether it has any crack or not and then proceed to remove the towel or clothing from the hole. Call your professional local plumbers if your flange has cracks. However, if the flange seems okay, pull the rag off the hole and remove closet bolts. After that, install a new seal and hook closet bolts in the flange slots. Caution, never install the new seal before removing the clothing or towel from the hole. Leaving the cloth in will not only complicate the process but cost you a lot of money.

3. Remove the Old Toilet

Homeowners will have to fix the trim caps that are often installed at the base of the toilet before removing the old toilet. You want to remove and loosen up the washers and nuts securing the toilet’s closet bolts to the floor. You might need to use a hacksaw for removing rusty bolts as some may not loosen up with a spanner. Homeowners working alone should first disconnect the bowl and the tank and then remove the bowl later. Lifting the bowl and the tank separately will be a lot easier than lifting them together. After removing the nuts and washers on either side of the bowl, lift it gently to avoid breakages. An open line will be left on the sewer system once the homeowner removes the toilet. One way to prevent sewer gases from sneaking into the house and ensuring tools don’t get into the hole is to stuff a rag down into the hole.

4. Secure the Toilet

After placing the assembled toilet on the flange, line up the bolts and nuts with the holes in the base of the flange. Press the bowl a bit so that the wax ring forms a seal. Then put a few washers and nuts on each bolt and tighten them using a small wrench. However, don’t over-tighten them as this can damage the bowl. You can use a hacksaw cut any piece of a bolt that extends far over the washers and nuts.

4 Money Saving Tips for a Local Move

You might have read somewhere that the moving process can be stressful and financially draining. With several things to remember and do in a move like hiring movers, you are likely to forget to keep the process within your budget. Fortunately, you don’t have to worry about the move if you have a tight budget because you can use these tips to maintain the expenses within your budget and still relocate smoothly.

1. Control your expenses
You should first come up with a moving budget so that you make the relocation process cheap. A moving budget assists you to distribute costs efficiently among the tasks ahead of you. Also, a budget will signal you when a specific task requires extra money. As such, you will have better control of your expenses than if you didn’t have a budget so that you can use minor fixes to ensure that the funds you put aside for the relocation process will be enough.

2. Choose the best time to relocate
You can consider choosing the perfect time to move if you have a flexible schedule. You should use that opportunity to save on moving costs. For instance, you can make your move cheaper than usual by booking your move early enough because movers sometimes offer price discounts to customers who book early. Additionally, selecting a relocation date during the off-peak moving season, which is usually during the winter months, is an excellent way to save on moving costs. The chances are that you might save close to 20 percent of the moving expenses.

3. Sell the items you no longer use
Every piece of cloth, electronic or kitchen item that you no longer use is another dollar that you can use to settle the moving costs. Save yourself the trouble of moving things that you don’t need any more by doing a massive clean-out before you relocate. Besides making extra dollars to pay the moving expense, selling stuff you don’t use reduces the number of items to be transported. Notably, movers often charge based on the weight or number of items being moved and this could save you a few dollars too.

4. Pack on your own
Packing constitutes a significant part of the moving expenses. Therefore, you can significantly cut on your moving costs by packing on your own. That means that you only hire office mover Calgary to move your belongings to the new location. You can get help from your friends so that you save a few dollars on a local move. However, make sure that you get the right packing boxes or containers for all your items.

6 Items You Should Never Pack for a Move

When packing for a move there are a few items you need to scratch from your list due to the messy nature or dangers associated with transport. Most things on this list movers will not transport, even for short distances. Below are six of the top items to leave behind on your next move.

1. Cleaning Chemicals

As tempting as it seems to box up your selection of cleaning chemicals, like bleach and ammonia, getting rid of them or giving them away is the better option. Most moving companies will not transport these chemicals due to the potential for dangerous fumes when accidentally mixed. The risk is not worth taking, especially in long-distance moves.

2. Perishable Foods

Foods that are not shelf-stable can be tricky to move and be safe to consume at your final destination. Frozen items will begin to thaw the second you take them out of the freezer. Refrigerated items will need to remain in a cooler, which is hard to control and maintain the right temperature at all times. It means the food can be risky to consume.

3. Plants for Long-Distance Moves

Movers might also be unable to move plants over a long distance. Your alternative is to stick them in your personal auto and carry them yourself or find them a new home. Make sure you ask and get specific instructions before boxing up live plants.

4. Gasoline, Kerosene, or Propane

Gasoline, kerosene, and propane cannot be transported by professional residential mover Calgary companies for obvious reasons. It is a problem with the flammable and explosive qualities of the materials. Drivers that transport this type of material has to display special placards and need specific endorsements on their license. You can carry them in your personal vehicle, but consider whether it’s worth the risk.

5. Aerosols and Pressurized Materials

Anything that’s in aerosol form is under pressure and subject to exploding with impact damage. Any containers you have that are under pressure will typically be refused for transport. Exploding metal sends fragments out that can hurt people, destroy other packed items, or damage the moving equipment.

6. Solvents and Acid Solutions

As innocent as nail polish remover seems, it’s considered a solvent and will be refused to transport. Any acid solutions used to clean toilet bowl rings, auto parts, and other various tasks should be left behind. Contact your local waste management service to find out the safest disposal methods.

Check with your movers to make sure you are packing the items that are safe and acceptable to transport.

Home

4 Ways to Organize Your Packing Before Movers Arrive

Residential or office moving is generally a hectic time for everyone involved. Although the movers will handle the major tasks associated with relocating to a new place, you will probably have to pack some things to go with the moving van when the time comes. To make it easy for the moving crew to identify and correctly place packed items in their new location, you can use any of the following organizational strategies.

1. Color Coding

With numerous packing products available, you can choose boxes, bins, or labels in various colors to coordinate your packing efforts. For example, you can pack your bathroom supplies in a green-coded container. Bedroom items might be placed in blue-based crates or boxes. Each room or area of the home could be packed and listed as a specific color for easy reference by movers or family members when the goods are delivered to the new location.

2. Sized Containers

Depending on the various items you are packing for the move, you may be able to place larger items in the biggest bin style available, with medium items in mid-size containers, and the smaller possessions in the smallest packing boxes. There will still be some variability, since most if not all rooms in the new place will likely require items of all sizes, but at least size distinctions can begin to separate largest from smallest for ready reference.

3. Container Styles

You might be able to divide up your household possessions to be moved to fit into different styles of packing containers. Boxes can be used for clothing, shoes, and holiday decorations, for example, while crates are more solid for books and appliances like lamps or blenders. Larger bins might be reserved for heavier things, like light furniture such as accent tables or folding chairs.

4. Location of Containers

Another way to organize the furnishings to be moved is to set them in specific rooms of your current dwelling, and mark them accordingly for the destination location. For example, bathroom items could be packed and labeled, and placed in the bathroom so movers know where they go at the new location. However, they must be labeled as well as located for the new location.

There are many ways to pack your belongings in preparation for the movers’ truck. The main goal is to arrange everything in such a way that it is easy to identify the contents of a packing carton as well as be able to determine where it will go at the new place. With a plan in mind, your packing can be done neatly and logically so that everyone knows where things should go on moving day. To learn about moving, visit Hudson Movers

Home

6 Reasons Why You Need Locksmith Services

Security in the recent era has become a significant concern. You need to take care of the lives of your family members as well as property in your commercial building or at home. Consequently, locksmith services have become crucial for both homeowners and commercial property owners. Several situations necessitate the services of locksmiths including:

1. You have been locked out
Most people have at some point been locked out of their homes or offices. You might have misplaced your office keys or stepped out of your apartment without your keys and found yourself on the opposite side of your locked door. You do not have to stand there in the cold or sun waiting for someone to bring you an extra key or worst still, break into the home or office. You can save yourself the trouble by hiring professional locksmiths to assist you.

2. You have recently moved, and you need the locks changed
The other situation when most people hire locksmiths is after moving into a new home or apartment. Usually, it is advisable to change the locks after relocating into a new home to secure it. You should never make the mistake of attempting to change the locks without professional help. You need to call an expert to change the locks and ensure that the new locks are safe and that they are securely installed.

3. You accidentally shut yourself out of your car
Car keys are more sophisticated than the basic locks. As such, you cannot destroy your car keys. Therefore, you need to hire locksmith services that specialize in automotive security if you have locked yourself out of your car. These locksmiths know how to cut car keys, but they must get information about the code of the vehicle’s manufacturer so that they replicate using a similar locking mechanism. Notably, you must hire a professional in automotive security, rather than the basic locksmiths.

4. Installing an electronic lock system
Electronic lock systems offer maximum security as opposed to the traditional locks. However, they cannot guarantee your safety if they are not installed correctly. You should hire professional locksmith services to install security systems in your home or office. You should not gamble with your security by installing the systems on your own.

5. Warn out locks
Locks last for several years, but they wear out over time. Worn out locks put you at risk of burglary or emergencies. It is time to call a professional immediately you notice that your locks are not functioning as effectively as they should. The expert should replace the locks with new and efficient locks.

6. Repairing the existing access systems
Locksmiths not only install access systems but also fixing the current systems. The experts can repair or replace the entire access system if it is not functional. You shouldn’t compromise on your office or home security by overlooking faulty access systems.

For more information, visit Lockup Services.